2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Display Signal Circuit between Clock Assembly and Television Camera Assembly

Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This is the display signal circuit of the television camera assembly.

WIRING DIAGRAM

E150790E07

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - TELEVISION CAMERA ASSEMBLY)

  1. E146936E09
    Disconnect clock assembly connector E9.

  1. E150736E08
    Disconnect television camera assembly connector S1.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    S1-2 (CV+) - E9-14 (V+)
    Always
    Below 1 Ω
    S1-3 (CGND) - E9-4 (CGND)
    Always
    Below 1 Ω
    S1-4 (CB+) - E9-12 (CA+)
    Always
    Below 1 Ω
    S1-1 (CV-) - E9-15 (V-)
    Always
    Below 1 Ω
    S1-2 (CV+) - Body ground
    Always
    10 kΩ or higher
    S1-3 (CGND) - Body ground
    Always
    10 kΩ or higher
    S1-4 (CB+) - Body ground
    Always
    10 kΩ or higher
    S1-1 (CV-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT CLOCK ASSEMBLY

  1. E153724E02
    Reconnect clock assembly connector E9.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E9-12 (CA+) - E9-4 (CGND)
    Ignition switch on (IG)
    Shift lever R position
    Approx. 6 V



NG
REPLACE CLOCK ASSEMBLY (Click here)
OK


3. INSPECT TELEVISION CAMERA ASSEMBLY

  1. Reconnect clock assembly connector E9 and television camera assembly connector S1.E150777E01

  1. Check the waveform of the television camera assembly using an oscilloscope.

    OK:
    Pulses as shown in the illustration.

    Item
    Content
    Terminal No. (Symbols)
    S1-2 (CV+) - S1-1 (CV-)
    Tool
    0.2 V/DIV., 0.2 μsec./DIV.
    Condition
    Ignition switch on (IG), Shift lever R position



NG
REPLACE TELEVISION CAMERA ASSEMBLY (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Display Signal Circuit between Clock Assembly and Television Camera Assembly (May 2007 – Jul 2008)Display Signal Circuit between Clock Assembly and Television Camera Assembly (from Jul 2010) →