2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

B15E1 Media Malfunction

Diagnostic trouble codes · Vehicles built from Jul 2010

DESCRIPTION

This DTC is stored when the navigation receiver assembly cannot read the media.
DTC No.
DTC Detection Condition
Trouble Area
B15E1
When one of the conditions below is met:
  1. An unsuitable disc is inserted.
  2. The disc cannot be read.
  3. The disc cannot be read because of dirt or scratches.
  4. The disc cannot be read because it is inserted upside down.
  5. The disc cannot be read because a high or low temperature is detected.
  6. Internal power supply abnormality
  7. There are no playable files.
  8. The disc contains unreadable copy-protected content.
  1. CD
  2. Navigation receiver assembly

INSPECTION PROCEDURE


1. CHECK DISC

  1. I100152
    Check that the disc is not deformed or cracked.

    OK:
    No deformation or cracks on the disc



NG
CHANGE DISC
OK


2. DISC CLEANING

  1. I100151
    Disc cleaning
    1. If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.

      NOTICE:
      Do not use a conventional record cleaner or anti-static preservative.


NEXT


3. REPLACE DISC WITH ANOTHER AND RECHECK
  1. Replace the disc with another and recheck.

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

END


← B15DF USB Communication Malfunction (from Jul 2010)B15E7 Harddisk Reading/Writing Malfunction(Low Temperature) (+ B15E8) (from Jul 2010) →