2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

B15DF USB Communication Malfunction

Diagnostic trouble codes · Vehicles built from Jul 2010

DESCRIPTION

This DTC is stored when a malfunction occurs in communication with USB device or "iPod".
DTC No.
DTC Detection Condition
Trouble Area
B15DF
When one of the conditions below is met:
  1. Communication error with USB device
  2. "iPod" control software of system microprocessor malfunction
  3. Communication error with "iPod"
  1. USB device or "iPod"
  2. Connection cable
  3. Multi-media interface ECU

INSPECTION PROCEDURE


1. CHECK CONNECTION METHOD
  1. Check the method used to connect the USB device or "iPod" to the No. 1 stereo jack adapter assembly.

Result:
Result
Proceed to
USB device or "iPod" is connected using a connection cable.
A
USB device is directly connected.
B



B
Go to step 5
A


2. REPLACE CONNECTION CABLE
  1. Disconnect the USB device or "iPod" and connection cable from the No. 1 stereo jack adapter assembly.

  1. Turn the ignition switch off.

    HINT:
    When DTC has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the ignition switch to ACC.

  1. Connect a known good connection cable to the No. 1 stereo jack adapter assembly and connect the USB device or "iPod" to the connection cable.


NEXT


3. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


4. CHECK DTC
  1. Recheck for DTCs and check if the same DTC is output again.

    HINT:
    If DTCs are detected frequently, replace the multi-media interface ECU.

    OK:
    No DTCs are output.



NG
Go to step 5
OK

END (CONNECTION CABLE WAS DEFECTIVE)

5. REPLACE "iPod"OR USB DEVICE
  1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

  1. Turn the ignition switch off.

    HINT:
    When DTC has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the ignition switch to ACC.

  1. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

    HINT:
    If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.


NEXT


6. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


7. RECHECK DTC
  1. Recheck for DTCs and check if the same DTC is output again.

    HINT:
    If DTCs are detected frequently, replace the multi-media interface ECU.

    OK:
    No DTCs are output.



NG
REPLACE MULTI-MEDIA INTERFACE ECU (Click here)
OK

USB DEVICE OR "iPod" WAS DEFECTIVE


← B15C2 Speed Signal Malfunction (from Jul 2012)B15E1 Media Malfunction (from Jul 2010) →