Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for DVD)
Reverse Signal Circuit
Circuit diagnosis · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The navigation receiver assembly receives a reverse signal from the park/neutral position switch and information about the GPS antenna, and then adjusts the vehicle position on the navigation display. WIRING DIAGRAM
INSPECTION PROCEDURE
1. INSPECT NAVIGATION RECEIVER ASSEMBLY
Disconnect navigation receiver assembly connector E4.
Measure the voltage according to the value(s) in the table below.
Standard voltage:
Tester Connection
Condition
Specified Condition
E4-5 (REV) - Body ground
Ignition switch on (IG) Shift lever R position
11 to 14 V
E4-5 (REV) - Body ground
Ignition switch on (IG) Shift lever any position except R
Below 1 V
NG
OK
2. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH)
Disconnect navigation receiver assembly connector E4.
Disconnect park/neutral position switch connector B5.
Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection
Condition
Specified Condition
E4-5 (REV) - B5-1 (RL)
Always
Below 1 Ω
E4-5 (REV) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
3. CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH - BATTERY)
Measure the voltage according to the value(s) in the table below.
Standard voltage:
Tester Connection
Condition
Specified Condition
B5-2 (RB) - Body ground
Ignition switch on (IG)
11 to 14 V
Result:
Result
Proceed to
NG
A
OK (for U151E)
B
OK (for U151F)
C
B
REPLACE PARK/NEUTRAL POSITION SWITCH (for U151E) (Click here )
C
REPLACE PARK/NEUTRAL POSITION SWITCH (for U151F) (Click here )
A
REPAIR OR REPLACE HARNESS OR CONNECTOR