2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Reverse Signal Circuit

Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The navigation receiver assembly receives a reverse signal from the park/neutral position switch and information about the GPS antenna, and then adjusts the vehicle position on the navigation display.

WIRING DIAGRAM

E150789E03

INSPECTION PROCEDURE


1. INSPECT NAVIGATION RECEIVER ASSEMBLY

  1. E141022E09
    Disconnect navigation receiver assembly connector E4.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E4-5 (REV) - Body ground
    Ignition switch on (IG)
    Shift lever R position
    11 to 14 V
    E4-5 (REV) - Body ground
    Ignition switch on (IG)
    Shift lever any position except R
    Below 1 V



NG
Go to step 2
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

2. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH)

  1. E150782E04
    Disconnect navigation receiver assembly connector E4.

  1. Disconnect park/neutral position switch connector B5.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E4-5 (REV) - B5-1 (RL)
    Always
    Below 1 Ω
    E4-5 (REV) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH - BATTERY)

  1. E150783E03
    Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    B5-2 (RB) - Body ground
    Ignition switch on (IG)
    11 to 14 V

    Result:
    Result
    Proceed to
    NG
    A
    OK (for U151E)
    B
    OK (for U151F)
    C



B
REPLACE PARK/NEUTRAL POSITION SWITCH (for U151E) (Click here)

C
REPLACE PARK/NEUTRAL POSITION SWITCH (for U151F) (Click here)
A

REPAIR OR REPLACE HARNESS OR CONNECTOR


← Reverse Signal Circuit (May 2007 – Jul 2008)Reverse Signal Circuit (from Jul 2010) →