2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Mute Signal Circuit between Navigation Receiver Assembly and Multi-media Interface ECU

Circuit diagnosis · Vehicles built from Jul 2010

DESCRIPTION

The navigation receiver assembly controls the volume according to the mute signal from the multi-media interface ECU.
The mute signal is sent to reduce noise and popping sounds, such as those generated when changing sources. If there is an open in the circuit, noise can be heard from the speakers when changing the sound source. If there is a short in the circuit, even though the navigation receiver assembly is functioning normally, no sound or only an extremely faint sound can be heard.

WIRING DIAGRAM

E176573E43

INSPECTION PROCEDURE


1. INSPECT MULTI-MEDIA INTERFACE ECU

  1. E176580E31
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E25-6 (MUT1) - Body ground
    Ignition switch ACC, USB audio system or satellite radio playing → Changing sources
    Above 3.5 V → Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Multi-media Interface ECU)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - MULTI-MEDIA INTERFACE ECU)
  1. Disconnect the E23 navigation receiver assembly connector.

  1. Disconnect the E25 multi-media interface ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E23-6 (MUTE) - E25-6 (MUT1)
    Always
    Below 1 Ω
    E23-6 (MUTE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. REPLACE MULTI-MEDIA INTERFACE ECU
  1. Replace the multi-media interface ECU and check that the malfunction disappears (Click here).

    OK:
    Malfunction disappears.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END


← Reverse Signal Circuit (from Jul 2010)Microphone Circuit between Microphone and Navigation Receiver Assembly (from Jul 2010) →