2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Navigation Receiver Assembly Power Source Circuit

Circuit diagnosis · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This is the power source circuit to operate the navigation receiver assembly.

WIRING DIAGRAM

E192525E05

INSPECTION PROCEDURE


1. INSPECT NAVIGATION RECEIVER ASSEMBLY
  1. Disconnect the E6 navigation receiver assembly connector.

  1. Disconnect the E4 navigation receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below .

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E6-7 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E6-4 (B) - E6-7 (GND)
    Always
    11 to 14 V
    E6-3 (ACC) - E6-7 (GND)
    Ignition switch ACC
    11 to 14 V
    E4-2 (IG) - E6-7 (GND)
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Navigation Receiver Assembly Power Source Circuit (Aug 2008 – Jun 2010)Navigation Receiver Assembly Communication Error (May 2007 – Jul 2008) →