C1511 Torque Sensor Circuit Malfunction
Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010
Also covers:
- C1512 Torque Sensor Circuit Malfunction
- C1513 Torque Sensor Circuit Malfunction
- C1514 Torque Sensor Power Supply Abnormal
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The torque sensor converts the rotation torque input from the steering wheel into electric signals and sends them to the power steering ECU.| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1511 |
Torque sensor (TRQ1) signal error or stop |
|
| C1512 |
Torque sensor (TRQ2) signal error or stop |
|
| C1513 |
Deviation between torque sensor TRQ1 and TRQ2 exceeds specified value |
|
| C1514 |
Torque sensor power source voltage error |
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK CONNECTOR CONNECTION CONDITION (TORQUE SENSOR - POWER STEERING ECU) |
Check the installation condition of the torque sensor connector.
- OK:
- Torque sensor connector is securely installed to the power steering ECU.
- Result:
Result
Proceed to
NG
A
OK
B
|
|
||||
| A | |
| 2. RECONFIRM DTC |
Reinstall the torque sensor connector.
Check for DTCs (Click here).
- OK:
- DTC is not output.
- Result:
Result
Proceed to
DTC is output
A
DTC is not output
B
|
|
||||
| A | |
| 3. CHECK TORQUE SENSOR |
Turn the ignition switch on (IG).

Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
z5-1 (TRQ1) - z5-6 (TRQG)
Steering wheel not turned (without load)
2.3 to 2.7 V
Steering wheel turned to right with vehicle stopped
2.5 to 4.04 V
Steering wheel turned to left with vehicle stopped
0.95 to 2.5 V
z5-5 (TRQ2) - z5-6 (TRQG)
Steering wheel not turned (without load)
2.3 to 2.7 V
Steering wheel turned to right with vehicle stopped
0.95 to 2.5 V
Steering wheel turned to left with vehicle stopped
2.5 to 4.04 V
z5-3 (TRQF) - z5-6 (TRQG)
Always
3.35 to 3.37 V
z5-4 (TRQV) - z5-6 (TRQG)
Always
8.5 to 10.5 V
|
|
||||
| OK | ||
| ||
