2007-2013 Highlander Kluger · Service Manual STEERING

C1511 Torque Sensor Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Jul 2010

Also covers:

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The torque sensor converts the rotation torque input from the steering wheel into electric signals and sends them to the power steering ECU.
DTC No.
DTC Detection Condition
Trouble Area
C1511
Torque sensor (TRQ1) signal error or stop
  1. Steering column assembly (Torque sensor)
  2. Power steering ECU
C1512
Torque sensor (TRQ2) signal error or stop
C1513
Deviation between torque sensor TRQ1 and TRQ2 exceeds specified value
C1514
Torque sensor power source voltage error

WIRING DIAGRAM

C170024E01

INSPECTION PROCEDURE


1. CHECK CONNECTOR CONNECTION CONDITION (TORQUE SENSOR - POWER STEERING ECU)
  1. Check the installation condition of the torque sensor connector.

    OK:
    Torque sensor connector is securely installed to the power steering ECU.

    Result:
    Result
    Proceed to
    NG
    A
    OK
    B



B
Go to step 3
A


2. RECONFIRM DTC
  1. Reinstall the torque sensor connector.

  1. Check for DTCs (Click here).

    OK:
    DTC is not output.

    Result:
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
END
A


3. CHECK TORQUE SENSOR

  1. C166749E02
    Turn the ignition switch on (IG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    z5-1 (TRQ1) - z5-6 (TRQG)
    Steering wheel not turned (without load)
    2.3 to 2.7 V
    Steering wheel turned to right with vehicle stopped
    2.5 to 4.04 V
    Steering wheel turned to left with vehicle stopped
    0.95 to 2.5 V
    z5-5 (TRQ2) - z5-6 (TRQG)
    Steering wheel not turned (without load)
    2.3 to 2.7 V
    Steering wheel turned to right with vehicle stopped
    0.95 to 2.5 V
    Steering wheel turned to left with vehicle stopped
    2.5 to 4.04 V
    z5-3 (TRQF) - z5-6 (TRQG)
    Always
    3.35 to 3.37 V
    z5-4 (TRQV) - z5-6 (TRQG)
    Always
    8.5 to 10.5 V



NG
REPLACE STEERING COLUMN ASSEMBLY (Click here)
OK

REPLACE POWER STEERING ECU (Click here)


← C1511 Torque Sensor Circuit Malfunction (+ C1512, C1513, C1514) (Aug 2008 – Jun 2010)C1521 Motor Circuit Malfunction (May 2007 – Jul 2008) →