2007-2013 Highlander Kluger · Service Manual STEERING

C1531 ECU Malfunction

Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008

Also covers:

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

If the power steering ECU detects these DTCs, it will shut off the motor relay circuit (built into the power steering ECU) and stop power assist. However, power assist continues if DTC C1533 is output.
DTC No.
DTC Detection Condition
Trouble Area
C1531
ECU internal malfunction (CPU malfunction)
Power steering ECU
C1532
ECU internal malfunction (Peripheral circuit malfunction)
Power steering ECU
C1533
ECU internal malfunction (Substrate temperature sensor malfunction)
Power steering ECU
C1534
ECU internal malfunction (EEPROM error)
Power steering ECU

INSPECTION PROCEDURE


1. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Check for DTC (Click here).

    OK:
    DTC is not output.



NG
REPLACE POWER STEERING ECU (Click here)
OK

CHECK INTERMITTENT PROBLEMS


← C1528 Motor Rotation Angle Sensor Malfunction (from Jul 2010)C1531 ECU Malfunction (+ C1532, C1533, C1534) (Aug 2008 – Jun 2010) →