2007-2013 Highlander Kluger · Service Manual STEERING

U0073 Control Module Communication Bus OFF

Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008

Also covers:

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

DESCRIPTION

The power steering ECU receives signals from the ECM and the skid control ECU via the CAN communication system.
DTC No.
DTC Detection Condition
Trouble Area
U0073
Control module communication bus off
CAN communication system
U0100
Lost communication with ECM/PCM "A"
  1. CAN communication system
  2. ECM
U0129
Lost communication with brake system control module
  1. CAN communication system
  2. Skid control ECU

HINT:
  1. When 2 or more DTCs starting with [U] are output simultaneously, inspect the connectors and wire harness of each ECU.
  2. If DTC U0100 is output, first erase the DTCs. Then turn the ignition switch from off to on (IG). If DTC U0100 is not output again, there is no malfunction.


WIRING DIAGRAM

C170031E01
C170030E01

INSPECTION PROCEDURE


1. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC is not output.



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK

CHECK INTERMITTENT PROBLEMS


← C1581 Assist Map Number Un-Writing (from Jul 2010)U0073 Control Module Communication Bus OFF (+ U0100, U0129) (Aug 2008 – Jun 2010) →