2007-2013 Highlander Kluger · Service Manual STEERING

C1524 Motor Circuit Malfunction

Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008

Also covers:

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The power steering ECU supplies current to the power steering motor through the motor circuit.
DTC No.
DTC Detection Condition
Trouble Area
C1524
Short (or open) in motor circuit or abnormal voltage or current in motor circuit
  1. Steering column assembly (Power steering motor)
  2. Power steering ECU
C1555
Motor relay circuit malfunction

WIRING DIAGRAM

C170026E01

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (MOTOR VOLTAGE)
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Chassis / EMPS / Data List.

  1. Select the items "Motor Terminal Volt(U)", "Motor Terminal Volt(V)", "Motor Terminal Volt(W)" in the Data List and read the value displayed on the intelligent tester.

    EMPS: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Motor Terminal Volt(U)
    Motor terminal voltage (U phase):
    Min.: 0 V
    Max.: 46.667 V
    When the steering wheel is turned, a voltage between 1 V and approximately 1 V less than the battery voltage is displayed.
    Engine running and steering wheel is turned
    Motor Terminal Volt(V)
    Motor terminal voltage (V phase):
    Min.: 0 V
    Max.: 46.667 V
    When the steering wheel is turned, a voltage between 1 V and approximately 1 V less than the battery voltage is displayed.
    Engine running and steering wheel is turned
    Motor Terminal Volt(W)
    Motor terminal voltage (W phase):
    Min.: 0 V
    Max.: 46.667 V
    When the steering wheel is turned, a voltage between 1 V and approximately 1 V less than the battery voltage is displayed.
    Engine running and steering wheel is turned

    Result:
    Result
    Proceed to
    When the steering wheel is turned, a voltage between 1 V and approximately 1 V less than the battery voltage is displayed.
    A
    When the steering wheel is turned, a value other than the above is displayed.
    B



B
REPLACE STEERING COLUMN ASSEMBLY (Click here)
A

REPLACE POWER STEERING ECU (Click here)


← C1521 Motor Circuit Malfunction (from Jul 2010)C1524 Motor Circuit Malfunction (+ C1555) (Aug 2008 – Jun 2010) →