2007-2013 Highlander Kluger · Service Manual ENGINE

P0560 System Voltage

Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The battery supplies electricity to the ECM even when the ignition switch is off. This power allows the ECM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, these memories are cleared and the ECM determines that there is a malfunction in the power supply circuit. When the engine is next started, the ECM will illuminate the MIL and set the DTC.
DTC No.
DTC Detection Condition
Trouble Area
P0560
Open in ECM back-up power source circuit
(1 trip detection logic)
  1. Open in back-up power source circuit
  2. EFI No. 1 fuse
  3. ECM

HINT:
If DTC P0560 is set, the ECM does not store other DTCs.


WIRING DIAGRAM

A118508E27

INSPECTION PROCEDURE

HINT:
Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.


1. CHECK FUSE (EFI NO. 1 FUSE)

  1. A168235E04
    Remove the EFI No.1 fuse from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    EFI No. 1 Fuse
    Always
    Below 1 Ω

  1. Reinstall the EFI No. 1 fuse.



NG
CHECK FOR SHORT IN ALL HARNESS AND COMPONENTS CONNECTED TO FUSE, AND REPLACE FUSE (EFI NO. 1 FUSE)
OK


2. INSPECT ECM (BATT VOLTAGE)

  1. A168199E06
    Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D31-3 (BATT) - B3-1 (E1)
    Always
    9 to 14 V



NG
Go to step 3
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)

3. CHECK HARNESS AND CONNECTOR (ECM - EFI NO. 1 FUSE)

  1. A168253E02
    Remove the EFI No. 1 fuse from the relay block.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance (Check for open):
    Tester Connection
    Condition
    Specified Condition
    EFI No. 1 fuse (2) - D31-3 (BATT)
    Always
    Below 1 Ω

    Standard resistance (Check for short):
    Tester Connection
    Condition
    Specified Condition
    EFI No. 1 fuse (2) or D31-3 (BATT) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the ECM connector.

  1. Reinstall the EFI No. 1 fuse.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

CHECK AND REPLACE ENGINE ROOM RELAY BLOCK


← P0505 Idle Control System Malfunction (from Jul 2010)P0560 System Voltage (Aug 2008 – Jun 2010) →