2007-2013 Highlander Kluger · Service Manual BODY

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Side)

  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    1. Do not apply voltage to any terminals except terminals 1 and 2, to avoid damaging the pulse sensor inside the motor.
    1. Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly onto the door.


    B172246E01

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1, 2, 4, 7 and 10.

    OK:
    Switch Condition
    Measurement Condition
    Specified Condition
    Manual Operation
    Battery positive (+) → Terminal 2 (B)
    Battery negative (-) → Terminal 1 (E), 7 (DWN1)
    Motor gear rotates counterclockwise
    Battery positive (+) → Terminal 2 (B)
    Battery negative (-) → Terminal 1 (E), 10 (UP1)
    Motor gear rotates clockwise
    Auto Operation
    Battery positive (+) → Terminal 2 (B)
    Battery negative (-) → Terminal 1 (E), 4 (AUTO), 7 (DWN1)
    Motor gear rotates counterclockwise
    Battery positive (+) → Terminal 2 (B)
    Battery negative (-) → Terminal 1 (E), 4 (AUTO), 10 (UP1)
    Motor gear rotates clockwise

    If the result is not as specified, replace the regulator motor assembly.


INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Front Passenger Side)

  1. Apply battery voltage to connector terminals 1 and 2.

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1 and 2.


    B164425E02

  1. Check that the motor gear rotates smoothly as follows.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 1
    Battery negative (-) → 2
    Motor gear rotates clockwise
    Battery positive (+) → 2
    Battery negative (-) → 1
    Motor gear rotates counterclockwise

    If the result is not as specified, replace the regulator motor assembly.


INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Side)

  1. B164426E05
    Apply battery voltage to connector terminals 1 and 2.

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1 and 2.

  1. Check that the motor gear rotates smoothly as follows.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 1
    Battery negative (-) → 2
    Motor gear rotates clockwise
    Battery positive (+) → 2
    Battery negative (-) → 1
    Motor gear rotates counterclockwise

    If the result is not as specified, replace the regulator motor assembly.


INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear RH Side)

  1. B164427E04
    Apply battery voltage to connector terminals 1 and 2.

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1 and 2.

  1. Check that the motor gear rotates smoothly as follows.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 1
    Battery negative (-) → 2
    Motor gear rotates clockwise
    Battery positive (+) → 2
    Battery negative (-) → 1
    Motor gear rotates counterclockwise

    If the result is not as specified, replace the regulator motor assembly.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →