Before installation, apply high temperature grease to the parts indicated by arrows (Click here).
1.
INSTALL CABLE SUPPORT BRACKET
Install the cable support bracket to the No. 3 parking brake cable assembly.
2.
INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY
Install the No. 3 parking brake cable assembly with the 2 bolts and 4 nuts.
Torque:
Bolt (A):
8.5 N*m{
87 kgf*cm
, 75 in.*lbf
}
Bolt (B):
6.0 N*m{
61 kgf*cm
, 53 in.*lbf
}
Nut:
6.0 N*m{
61 kgf*cm
, 53 in.*lbf
}
Install the No. 3 parking brake cable assembly to the backing plate with the 2 bolts.
Torque:
8.0 N*m{
82 kgf*cm
, 71 in.*lbf
}
3.
INSTALL NO. 1 PARKING BRAKE CABLE SUPPORT BRACKET
Install the No. 1 parking brake cable support bracket to the No. 2 parking brake cable assembly.
4.
INSTALL PARKING BRAKE CABLE SUPPORT BRACKET
Install the parking brake cable support bracket to the No. 2 parking brake cable assembly.
5.
INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY
Install the No. 2 parking brake cable assembly with the 2 bolts and 5 nuts.
Torque:
Bolt (A):
8.5 N*m{
87 kgf*cm
, 75 in.*lbf
}
Bolt (B):
6.0 N*m{
61 kgf*cm
, 53 in.*lbf
}
Nut:
6.0 N*m{
61 kgf*cm
, 53 in.*lbf
}
Install the No. 2 parking brake cable assembly to the backing plate with the 2 bolts.
Torque:
8.0 N*m{
82 kgf*cm
, 71 in.*lbf
}
6.
APPLY HIGH TEMPERATURE GREASE
Apply high temperature grease to the backing plate which makes contact with the shoe.
7.
INSTALL NO. 2 PARKING BRAKE SHOE ASSEMBLY WITH PARKING BRAKE SHOE LEVER
Using needle-nose pliers, connect the No. 3 parking brake cable assembly to the parking brake shoe lever as shown in the illustration.
8.
INSTALL NO. 2 PARKING BRAKE SHOE RETURN TENSION SPRING
Install the No. 2 parking brake shoe return tension spring to the No. 2 parking brake shoe assembly.
9.
INSTALL NO. 1 PARKING BRAKE SHOE ASSEMBLY
Connect the No. 2 parking brake shoe return tension spring to install the No. 1 parking brake shoe assembly.
10.
INSTALL PARKING BRAKE SHOE ADJUSTING SCREW SET
Apply high temperature grease to the parking brake shoe adjusting screw set as shown in the illustration.
Install the parking brake shoe adjusting screw set.
11.
INSTALL NO. 2 PARKING BRAKE SHOE ASSEMBLY
Install the No. 2 parking brake shoe assembly to the backing plate with the No. 1 parking brake shoe hold down spring cup, parking brake shoe hold down spring, and No. 2 parking brake shoe hold down spring cup.
12.
INSTALL PARKING BRAKE SHOE STRUT
Install the parking brake shoe strut and the parking brake shoe strut compression spring.
13.
INSTALL NO. 1 PARKING BRAKE SHOE ASSEMBLY
Install the No. 1 parking brake shoe assembly to the backing plate with the No. 1 parking brake shoe hold down spring cup, parking brake shoe hold down spring, and No. 2 parking brake shoe hold down spring cup.
14.
INSTALL NO. 1 PARKING BRAKE SHOE RETURN TENSION SPRING