2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

INSTALLATION

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. INSTALL REAR EVAPORATOR TEMPERATURE SENSOR

  1. E151036
    Engage the claw and clamp.

  1. Connect the 3 connectors and install the rear evaporator temperature sensor.


2. INSTALL REAR NO. 5 AIR DUCT

  1. E149737
    Install the rear No. 5 air duct with the 2 clips.


3. INSTALL NO. 1 COOLER AIR DUCT

  1. E149735E01
    Install the No. 1 cooler air duct as shown in the illustration.


4. INSTALL COOLER PLATE

  1. E149734
    Engage the 2 claws and install the cooler plate.


5. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH

HINT:
Use the same procedure for the RH side and the LH side.


6. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH
  1. Engage the 4 clips and 7 claws.

  1. Install the 2 clips.

  1. Install the deck trim side panel assembly RH with the 3 bolts.

    B173622


7. INSTALL FRONT DECK SIDE TRIM COVER RH

HINT:
Use the same procedure for the RH side and the LH side.


8. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

HINT:
Use the same procedure for the No. 1 luggage compartment trim hook and the No. 2 deck side trim hook.


9. INSTALL ROPE HOOK ASSEMBLY (for RH Side)

HINT:
Use the same procedure for the RH side and the LH side.


10. INSTALL REAR COMBINATION LIGHT SERVICE COVER RH

  1. B173619
    Engage the 2 guides and 6 claws, and install the rear combination light service cover RH.


11. INSTALL SIDE TRIM COVER RH (for Manual Air Conditioning System)

  1. B173610
    Engage the 4 claws, and install the side trim cover RH.


12. INSTALL REAR ROOM TEMPERATURE SENSOR (for Automatic Air Conditioning System)
  1. Connect the connector.

  1. E150364
    Engage the 4 claws and install the rear room temperature sensor.


13. INSTALL DECK SIDE TRIM RH

HINT:
Use the same procedure for the RH side and the LH side.


14. INSTALL DECK SIDE TRIM COVER NO.1

HINT:
Use the same procedure for the RH side and the LH side.


15. INSTALL REAR SEAT SIDE GARNISH CAP

  1. B173617
    Engage the guide and 6 claws.

  1. Install the rear seat side garnish cap with the screw.


16. INSTALL REAR FLOOR FINISH PLATE

  1. B173609
    Engage the 4 clips and 4 claws, and install the rear floor finish plate.


17. INSTALL REAR NO. 2 SEAT ASSEMBLY
(Click here)

18. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH

  1. B173237E01
    Align the alignment mark (green) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip RH.

    NOTICE:
    After installation, check that the corners fit correctly.


19. INSTALL REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedure for the RH side and the LH side.

← INSTALLATION (Aug 2008 – Jun 2010)COMPONENTS (May 2007 – Jun 2010) →