C1379 Downhill Assist Control Switch Malfunction (Test Mode DTC)
Diagnostic trouble codes · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
DTC C1379 will be deleted when the downhill assist control switch sends a downhill assist control operation signal or when Test Mode ends. DTC C1379 is output only in Test Mode.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1379 |
Detected only during Test Mode. |
Downhill assist control switch |
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the brake actuator assembly, perform zero point calibration (Click here).
| 1. READ VALUE ON INTELLIGENT TESTER (DOWNHILL ASSIST CONTROL SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Select the Data List mode on the intelligent tester (Click here).
ABS / VSC / TRC: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Downhill Assist Control SW
Downhill assist control switch / ON or OFF
ON: Switch ON
OFF: Switch OFF
-
Using the intelligent tester, check the switch condition on the intelligent tester changes according to downhill assist control switch operation.
- OK:
- The intelligent tester displays ON or OFF according to downhill assist control switch operation.
|
|
||||
| OK | |
| 2. PERFORM TEST MODE (SIGNAL CHECK) |
Turn the ignition switch off.
Perform the sensor check in the Test Mode procedure (Click here).
- OK:
- All Test Mode DTCs are erased.
- HINT:
- If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).
|
|
||||
| OK | ||
| ||
| 3. INSPECT DOWNHILL ASSIST CONTROL SWITCH |
Turn the ignition switch off.

Make sure that there is no looseness at the locking part and the connecting part of the connector.
Disconnect the downhill assist control switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Switch Condition
Specified Condition
4 (B) - 1 (E)
Switch is pushed in
Below 1 Ω
4 (B) - 1 (E)
Switch is not pushed in
10 kΩ or higher
- NOTICE:
- Check the downhill assist control switch signal after replacement (Click here).
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DOWNHILL ASSIST CONTROL SWITCH) |
Make sure that there is no looseness at the locking part and the connecting part of the connector.

Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
A24-26 (HDCS) - g2-4 (B)
Always
Below 1 Ω
A24-26 (HDCS) - Body ground
Always
10 kΩ or higher
g2-1 (E) - Body ground
Always
Below 1 Ω
- HINT:
- If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).
|
|
||||
| OK | ||
| ||
