Microphone Circuit between Microphone and Navigation Receiver Assembly
Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
This circuit sends a microphone signal from the overhead junction block (microphone) to the navigation receiver assembly.It also supplies power from the navigation receiver assembly to the overhead junction block (microphone).
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (OVERHEAD JUNCTION BLOCK - NAVIGATION RECEIVER ASSEMBLY) |
Disconnect microphone connector Q10 and navigation receiver assembly connector E3.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
Q10-1 (ACC) - E3-17 (MACC)
Always
Below 1 Ω
Q10-3 (MI1+) - E3-19 (MIC+)
Always
Below 1 Ω
Q10-5 (MIC-) - E3-20 (MIC-)
Always
Below 1 Ω
E3-17 (MACC) - Body ground
Always
10 kΩ or higher
E3-19 (MIC+) - Body ground
Always
10 kΩ or higher
E3-20 (MIC-) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 2. INSPECT NAVIGATION RECEIVER ASSEMBLY |
Measure the voltage according to the value(s) in the table below.

- Standard voltage:
Tester Connection
Condition
Specified Condition
E3-17 (MACC) - Body ground
Ignition switch on (ACC)
4 to 6 V
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
E3-12 (TSW-) - E3-18 (SGND)
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
