2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Microphone Circuit between Microphone and Navigation Receiver Assembly

Circuit diagnosis · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This circuit sends a microphone signal from the telephone microphone assembly to the navigation receiver assembly.
It also supplies power from the navigation receiver assembly to the telephone microphone assembly.

WIRING DIAGRAM

E214558E01

INSPECTION PROCEDURE


1. INSPECT NAVIGATION RECEIVER ASSEMBLY

  1. E176579E34
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E3-17 (MACC) - Body ground
    Ignition switch ACC
    4 to 6 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E3-18 (SGND) - Body ground
    Always
    Below 1 Ω
    E3-20 (MIN-) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Component with harness connected
    (Navigation Receiver Assembly)



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEPHONE MICROPHONE ASSEMBLY)
  1. Disconnect the E3 navigation receiver assembly connector.

  1. Disconnect the Q15 telephone microphone assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E3-5 (SNS2) - Q15-4 (SNS2)
    Always
    Below 1 Ω
    E3-17 (MACC) - Q15-1 (MACC)
    Always
    Below 1 Ω
    E3-19 (MIN+) - Q15-3 (MIC+)
    Always
    Below 1 Ω
    E3-20 (MIN-) - Q15-5 (MIC-)
    Always
    Below 1 Ω
    E3-5 (SNS2) - Body ground
    Always
    10 kΩ or higher
    E3-17 (MACC) - Body ground
    Always
    10 kΩ or higher
    E3-19 (MIN+) - Body ground
    Always
    10 kΩ or higher
    E3-20 (MIN-) - Body ground
    Always
    10 kΩ or higher
    E3-18 (SGND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT TELEPHONE MICROPHONE ASSEMBLY

  1. E176581E13
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Q15-4 (SNS2) - Q15-5 (MIC-)
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Telephone Microphone Assembly)



NG
REPLACE TELEPHONE MICROPHONE ASSEMBLY (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Microphone Circuit between Microphone and Navigation Receiver Assembly (Aug 2008 – Jun 2010)Television Camera ECU Communication Error (May 2007 – Jul 2008) →