2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Microphone Circuit between Microphone and Navigation Receiver Assembly

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This circuit sends a microphone signal from the overhead junction block (microphone) to the navigation receiver assembly.
It also supplies power from the navigation receiver assembly to the overhead junction block (microphone).

WIRING DIAGRAM

E147390E04

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (OVERHEAD JUNCTION BLOCK - NAVIGATION RECEIVER ASSEMBLY)

  1. E153685E02
    Disconnect microphone connector Q10 and navigation receiver assembly connector E3.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    Q10-1 (ACC) - E3-17 (MACC)
    Always
    Below 1 Ω
    Q10-3 (MI1+) - E3-19 (MIC+)
    Always
    Below 1 Ω
    Q10-5 (MIC-) - E3-20 (MIC-)
    Always
    Below 1 Ω
    E3-17 (MACC) - Body ground
    Always
    10 kΩ or higher
    E3-19 (MIC+) - Body ground
    Always
    10 kΩ or higher
    E3-20 (MIC-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT NAVIGATION RECEIVER ASSEMBLY

  1. E153730E02
    Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E3-17 (MACC) - Body ground
    Ignition switch on (ACC)
    4 to 6 V



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY)

  1. E141024E09
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E3-12 (TSW-) - E3-18 (SGND)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Reverse Signal Circuit (from Jul 2010)Microphone Circuit between Microphone and Navigation Receiver Assembly (Aug 2008 – Jun 2010) →