2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Vehicle Speed Signal Circuit between Navigation Receiver Assembly and Combination Meter

Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010

DESCRIPTION

Navigation function:
The navigation receiver assembly receives a vehicle speed signal from the combination meter and information about the GPS antenna, and then adjusts vehicle position.
ASL (Automatic Sound Levelizer) function:
The circuit is necessary for the ASL built into the navigation receiver assembly.
Speed signals are received from the combination meter and used for the ASL.
The ASL function automatically adjusts the sound data in order to enable to hear the clear audio sound even when vehicle noise increases (as vehicle noise increases, the volume is turned up etc.).

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter. The signal is changed to a pulse signal at the transistor in the combination meter. Each ECU controls the respective system based on the pulse signal.
  2. If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.


WIRING DIAGRAM

E153705E02

INSPECTION PROCEDURE


1. INSPECT COMBINATION METER ASSEMBLY (OUTPUT WAVEFORM)

  1. E152386E01
    Check the output waveform.
    1. Remove the combination meter assembly with the connector still connected.

    2. Connect an oscilloscope to terminals E1-9 (+S) and body ground.

    3. Ignition switch on (IG).

    4. Turn the wheel slowly.

    5. Check the signal waveform according to the condition(s) in the table below.

      Item
      Condition
      Tool setting
      5 V/DIV., 20 ms./DIV.
      Vehicle condition
      Driving at approx. 20 km/h (12 mph)

      OK:
      The waveform is displayed as shown in the illustration.

      HINT:
      When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - COMBINATION METER)

  1. E150778E02
    Disconnect navigation receiver assembly connector E4 and combination meter connector E1.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E4-3 (SPD) - E1-9 (+S)
    Always
    Below 1 Ω



NG
Go to step 3
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

3. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - JUNCTION CONNECTOR)

  1. E153723E01
    Disconnect junction connector E17.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E17-3 - E4-3 (SPD)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - JUNCTION CONNECTOR)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (JUNCTION CONNECTOR)


← Vehicle Speed Signal Circuit between Navigation Receiver Assembly and Combination Meter (May 2007 – Jul 2008)Steering Pad Switch Circuit (May 2007 – Jul 2008) →