2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter

Circuit diagnosis · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

for Automatic Sound Levelizer (ASL):
  1. This circuit is necessary for the Automatic Sound Levelizer (ASL) built into the radio receiver.
    The Automatic Sound Levelizer (ASL) function automatically adjusts the audio system volume level in order to compensate for increased vehicle noise (vehicle noise tends to increase as vehicle speed increases). The ASL adjusts the volume level based upon vehicle speed signals that it receives from the combination meter assembly.
for "Bluetooth":
  1. Speed signals are received from the combination meter assembly and used to cancel "Bluetooth" function operation.
    The radio receiver recognizes that the vehicle is being driven and makes it impossible to connect or register a "Bluetooth" device while driving.

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter. The signal is changed to a pulse signal at the transistor in the combination meter. Each ECU controls the respective system based on the pulse signal.
  2. If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.


WIRING DIAGRAM

E211393E01

INSPECTION PROCEDURE


1. INSPECT COMBINATION METER ASSEMBLY (OUTPUT WAVEFORM)

  1. E152386E15
    Check the output waveform.
    1. Remove the combination meter assembly with the connector still connected.

    2. Connect an oscilloscope to terminal E1-9 (+S) and body ground.

    3. Turn the ignition switch to ON.

    4. Turn a wheel slowly.

    5. Check the signal waveform according to the condition(s) in the table below.

      Item
      Condition
      Tool setting
      5 V/DIV., 20 ms./DIV.
      Vehicle condition
      Wheel being rotated

      OK:
      The waveform is similar to that shown in the illustration.

      HINT:
      When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.

      Text in Illustration 
      *a
      Component with harness connected
      (Combination Meter Assembly)



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMBINATION METER ASSEMBLY)
  1. Disconnect the radio receiver connector and the combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E2-3 (SPD) - E1-9 (+S)
    Always
    Below 1 Ω



NG
Go to step 3
OK

REPLACE RADIO RECEIVER (Click here)

3. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - JUNCTION CONNECTOR)
  1. Disconnect the junction connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E17-7 - E2-3 (SPD)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (RADIO RECEIVER - JUNCTION CONNECTOR)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (JUNCTION CONNECTOR)


← Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter (Aug 2008 – Jun 2010)Steering Pad Switch Circuit (May 2007 – Jul 2008) →