2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Navigation Receiver Assembly Power Source Circuit

Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This is the power source circuit to operate the navigation receiver assembly.

WIRING DIAGRAM

E153686E03

INSPECTION PROCEDURE


1. INSPECT NAVIGATION RECEIVER ASSEMBLY

  1. E153985E02
    Disconnect the navigation receiver assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E6-7 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E6-4 (B) - E6-7 (GND)
    Always
    11 to 14 V
    E6-3 (ACC) - E6-7 (GND)
    Ignition switch on (ACC)
    11 to 14 V
    E4-2 (IG) - E6-7 (GND)
    Ignition switch on (IG)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Navigation Receiver Assembly Power Source Circuit (May 2007 – Jul 2008)Navigation Receiver Assembly Power Source Circuit (from Jul 2010) →