Navigation Receiver Assembly Power Source Circuit
Circuit diagnosis · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
This is the power source circuit to operate the navigation receiver assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT NAVIGATION RECEIVER ASSEMBLY |
Disconnect the navigation receiver assembly connectors.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E6-7 (GND) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
E6-4 (B) - E6-7 (GND)
Always
11 to 14 V
E6-3 (ACC) - E6-7 (GND)
Ignition switch on (ACC)
11 to 14 V
E4-2 (IG) - E6-7 (GND)
Ignition switch on (IG)
11 to 14 V
|
|
||||
| OK | ||
| ||
