2007-2013 Highlander Kluger · Service Manual BRAKE

REASSEMBLY

Removal / installation · Vehicles built from May 2007


1. INSTALL BRAKE PEDAL PAD
  1. Install the brake pedal pad.


2. INSTALL BRAKE PEDAL BUSHING
  1. Apply lithium soap base glycol grease to 2 new brake pedal bushings.

  1. Install the 2 brake pedal bushings to the brake pedal sub-assembly.


3. INSTALL BRAKE PEDAL SHAFT COLLAR
  1. Install the brake pedal shaft collar to the brake pedal sub-assembly.


4. INSTALL BRAKE PEDAL SUB-ASSEMBLY

  1. C165377E01
    Install the brake pedal sub-assembly to the brake pedal support sub-assembly with the bolt and nut as shown in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. C165379
    Engage the 2 clamps.

← ADJUSTMENT (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →