B2786 No Response from Steering Lock ECU
Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
This DTC is output when LIN communication between the certification ECU (smart key ECU assembly) and steering lock ECU (steering lock actuator assembly) stops for more than 10 seconds.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2786 |
No communication between steering lock ECU (steering lock actuator assembly) and certification ECU (smart key ECU assembly) for more than 10 seconds |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When using the intelligent tester with the ignition switch off to troubleshoot:
- Connect the intelligent tester to the vehicle, and turn the courtesy switch on and off at 1.5-second intervals until communication between the tester and vehicle begins.
| 1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - STEERING LOCK ECU) |
Disconnect the D36 connector.

Disconnect the D10 connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
D36-10 (LIN) - D10-5 (LIN)
Always
Below 1 Ω
D36-10 (LIN) - Body ground
Always
10 kΩ or higher
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
D36-10 (LIN) - Body ground
Always
Below 1 V
|
|
||||
| OK | |
| 2. CHECK STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY) |
Disconnect the D10 connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
D10-1 (GND) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
D10-7 (B) - Body ground
Always
11 to 14 V
|
|
||||
| OK | |
| 3. REPLACE STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY) |
Replace the steering lock ECU (steering lock actuator assembly) with a normally-functioning or a new one (Click here).
Delete the DTC.
| NEXT | |
| 4. CHECK FOR DTC |
Recheck for DTC.
- Result:
Result
Proceed to
B2786 is not output
A
B2786 is output
B
|
|
||||
| A | ||
| ||
