B2321 Driver Side Door ECU Communication Stop
Diagnostic trouble codes · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
This DTC is output when LIN communication between the front power window regulator motor assembly LH*1/RH*2 and main body ECU (instrument panel junction block assembly) stops for more than 10 seconds.- HINT:
- *1: for LHD
- *2: for RHD
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2321 |
No communication between front power window regulator motor assembly LH*1/RH*2 and main body ECU (instrument panel junction block assembly) for more than 10 seconds |
|
WIRING DIAGRAM




INSPECTION PROCEDURE
- NOTICE:
- When using the intelligent tester with the ignition switch off to troubleshoot:
- Connect the intelligent tester to the vehicle, and turn the courtesy switch on and off at 1.5-second intervals until communication between the tester and vehicle begins.
| 1. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - FRONT POWER WINDOW REGULATOR MOTOR LH*1/RH*2) |
- HINT:
- *1: for LHD
- *2: for RHD


Disconnect the D8 connector.
Disconnect the H1*1 or G10*2 connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
D8-10 (LIN2) - H1*1-9 (LIN)
Always
Below 1 Ω
D8-10 (LIN2) - G10*2-9 (LIN)
Always
Below 1 Ω
D8-10 (LIN2) - Body ground
Always
10 kΩ or higher
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
D8-10 (LIN2) - Body ground
Always
Below 1 V
|
|
||||
| OK | |
| 2. CHECK FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH*1/RH*2 |
- HINT:
- *1: for LHD
- *2: for RHD
Disconnect the H1*1 or G10*2 connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
H1*1-2 (B) - Body ground
G10*2-2 (B) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
H1*1-2 (B) - Body ground
G10*2-2 (B) - Body ground
Always
11 to 14 V
|
|
||||
| OK | |
| 3. REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH*1/RH*2 |
- HINT:
- *1: for LHD
- *2: for RHD
Replace the front power window regulator motor assembly LH*1 or RH*2with a normally-functioning or a new one (Click here).
Clear the DTC.
| NEXT | |
| 4. CHECK FOR DTC |
Recheck for DTC.
- Result:
Result
Proceed to
B2321 is not output
A
B2321 is output
B
|
|
||||
| A | ||
| ||
