2007-2013 Highlander Kluger · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The following procedures is for the LH side.
  3. If the sensor rotor needs to be replaced, replace it together with the front drive outboard joint shaft assembly.
    (Click here)
    (Click here)


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (Click here)


2. REMOVE FRONT WHEEL

3. REMOVE NO. 1 ENGINE UNDER COVER

  1. A171855
    Remove the 6 bolts, 2 clips and No. 1 engine under cover.


4. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH

  1. B172795
    Remove the clip.

  1. Using a 4 mm hexagon wrench, remove the screw.

  1. B172796
    Peel off the front fender side protector and disengage the 3 clips, and then remove the front fender moulding sub-assembly.

  1. Remove the pad from the front fender moulding sub-assembly.

  1. Remove the 2 No. 4 clips from the front fender moulding sub-assembly.

  1. B172797E01
    Remove the front fender side protector from the front fender moulding sub-assembly.


5. REMOVE FRONT WHEEL OPENING EXTENSION PAD

  1. B174748
    Remove the 2 screws and front wheel opening extension pad.


6. REMOVE FRONT FENDER LINER

  1. B175996E01
    Remove the screw.

  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

  1. B174749
    Using a 4 mm hexagon wrench, remove the 2 screws.

  1. Remove the 2 grommets.

    HINT:
    The grommets need to be replaced with new ones because they will break when they are removed.

  1. B174751
    Remove the 5 clips, 8 screws and front fender liner LH.


7. REMOVE FRONT SPEED SENSOR

  1. C165817
    Disconnect the front speed sensor connector and remove the 2 clamps.

  1. C165805E01
    Remove the bolt and No. 2 sensor clamp from the body.

  1. C165808E01
    Remove the bolt, No. 1 sensor clamp, and flexible hose together from the shock absorber assembly.

  1. C165818E02
    Remove the bolt, resin clamp, and the front speed sensor.

    NOTICE:
    1. Prevent foreign matter from attaching to the front speed sensor tip.
    2. Clean the installation hole and the connect surface for the front speed sensor every time it is removed.

← REMOVAL (May 2007 – Jul 2008)REMOVAL (from Jul 2010) →