2007-2013 Highlander Kluger · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The following procedures is for the LH side.
  3. If the sensor rotor needs to be replaced, replace it together with the front drive outboard joint shaft assembly.
    (Click here)
    (Click here)


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE FRONT WHEEL

3. REMOVE FRONT FENDER LINER
(Click here)

4. REMOVE FRONT SPEED SENSOR

  1. C165817
    Disconnect the front speed sensor connector and remove the 2 clamps.

  1. C165805E01
    Remove the bolt and No. 2 sensor clamp from the body.

  1. C165808E01
    Remove the bolt, No. 1 sensor clamp, and flexible hose together from the shock absorber assembly.

  1. C165818E02
    Remove the bolt, resin clamp, and the front speed sensor.

    NOTICE:
    1. Prevent foreign matter from attaching to the front speed sensor tip.
    2. Clean the installation hole and the connect surface for the front speed sensor every time it is removed.

← REMOVAL (Aug 2008 – Jun 2010)INSTALLATION (May 2007 – Jul 2008) →