2007-2013 Highlander Kluger · Service Manual BODY

DISASSEMBLY

Removal / installation · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. REMOVE REAR FOG LIGHT BRACKET (w/ Rear Fog Light)

  1. E150934
    Loosen the 2 screws as shown in the illustration.

  1. E150062
    Disengage the clamp.

  1. E150828
    Disengage the 4 claws and remove the rear fog light bracket.


2. REMOVE REAR FOG LIGHT ASSEMBLY (w/ Rear Fog Light)

  1. E150063
    Remove the rear fog light assembly.


3. REMOVE REFLEX REFLECTOR ASSEMBLY LH

  1. B172723
    Remove the nut and reflex reflector assembly LH.


4. REMOVE REFLEX REFLECTOR ASSEMBLY RH

HINT:
Use the same procedure for the RH side and LH side.


5. REMOVE LOWER REAR BUMPER COVER
  1. Remove the 2 clips.

  1. Disengage the 10 claws and 2 guides, and remove the lower rear bumper cover.

    B172724


6. REMOVE REAR BUMPER ENERGY ABSORBER

  1. B172725
    Disengage the 2 guides and remove the rear bumper energy absorber.


7. REMOVE REAR BUMPER BAR

  1. B172726
    Remove the rear bumper bar from the rear bumper energy absorber.


8. REMOVE REAR BUMPER PLATE LH

  1. B172727
    Disengage the 3 claws and remove the rear bumper plate LH.


9. REMOVE REAR BUMPER PLATE RH

HINT:
Use the same procedure for the RH side and LH side.


10. REMOVE REAR BUMPER REINFORCEMENT

  1. B172728
    Remove the 6 nuts and rear bumper reinforcement.


11. REMOVE REAR BUMPER SIDE RETAINER LH

  1. B172729
    Remove the screw.

  1. Disengage the 2 claws and remove the rear bumper side retainer LH.


12. REMOVE REAR BUMPER SIDE RETAINER RH

HINT:
Use the same procedures for the RH side and LH side.


13. REMOVE NO. 2 REAR BUMPER SIDE SUPPORT LH

  1. B172730
    Remove the 2 screws.

  1. Disengage the 3 claws and remove the No. 2 rear bumper side support LH.


14. REMOVE NO. 2 REAR BUMPER SIDE SUPPORT RH

HINT:
Use the same procedures for the RH side and LH side.


15. REMOVE NO. 1 REAR BUMPER SIDE SUPPORT

  1. B172731
    Disengage the 2 claws and remove the No. 1 rear bumper side support.

    HINT:
    Use the same procedure for the RH side and LH side.

← REMOVAL (from Jul 2010)DISASSEMBLY (from Jul 2010) →