2007-2013 Highlander Kluger · Service Manual BODY

DISASSEMBLY

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. REMOVE REAR FOG LIGHT BRACKET (w/ Rear Fog Light)

  1. E150934
    Loosen the 2 screws as shown in the illustration.

  1. E150062
    Disengage the clamp.

  1. E150828
    Disengage the 4 claws and remove the rear fog light bracket.


2. REMOVE REAR FOG LIGHT ASSEMBLY (w/ Rear Fog Light)

  1. E150063
    Remove the rear fog light assembly.


3. REMOVE REFLEX REFLECTOR ASSEMBLY LH

  1. B256720
    Remove the screw.

  1. B256721
    Disengage the 2 claws and 2 guides and remove the reflex reflector assembly LH.


4. REMOVE REFLEX REFLECTOR ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.


5. REMOVE LOWER REAR BUMPER COVER

  1. B256718
    Disengage the 2 claws and remove the 2 outside moulding retainers.

  1. B256717
    Disengage the 8 claws and remove the lower rear bumper cover.


6. REMOVE REAR BUMPER MOULDING

  1. B256723
    Disengage the 2 claws and remove the 2 outside moulding retainers.

  1. B256722
    Disengage the 7 claws and remove the rear bumper moulding.


7. REMOVE REAR BUMPER ENERGY ABSORBER

  1. B260026
    Disengage the 2 guides and remove the rear bumper energy absorber.


8. REMOVE REAR BUMPER REINFORCEMENT

  1. B260036
    Remove the 6 nuts and rear bumper reinforcement.


9. REMOVE REAR BUMPER SIDE RETAINER LH

  1. B172729
    Remove the screw.

  1. Disengage the 2 claws and remove the rear bumper side retainer LH.


10. REMOVE REAR BUMPER SIDE RETAINER RH

HINT:
Use the same procedure as for the LH side.


11. REMOVE NO. 2 REAR BUMPER SIDE SUPPORT LH

  1. B172730
    Remove the 2 screws.

  1. Disengage the 3 claws and remove the No. 2 rear bumper side support LH.


12. REMOVE NO. 2 REAR BUMPER SIDE SUPPORT RH

HINT:
Use the same procedure as for the LH side.


13. REMOVE NO. 1 REAR BUMPER SIDE SUPPORT

  1. B172731
    Disengage the 2 claws and remove the No. 1 rear bumper side support.

    HINT:
    Use the same procedure for the RH side and LH side.

← DISASSEMBLY (May 2007 – Jun 2010)REASSEMBLY (May 2007 – Jun 2010) →