2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

DISASSEMBLY

Removal / installation · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. REMOVE REAR COMBINATION LIGHT BODY GASKET

  1. E150054
    Remove the rear combination light body gasket.

    NOTICE:
    1. Be sure to remove all traces of the old gasket from the body.
    2. Do not reuse the removed gasket. Be sure to install a new rear combination light body gasket to prevent water ingress.


2. REMOVE BACK UP LIGHT BULB

  1. E150055
    Turn the back up light bulb and the back up light socket in the direction indicated by the arrow and remove them as a unit.

  1. Remove the back up light bulb from the back up light socket.


3. REMOVE REAR TURN SIGNAL LIGHT BULB

  1. E150057
    Turn the rear turn signal light bulb and the rear turn signal light socket in the direction indicated by the arrow and remove them as a unit.

  1. Remove the rear turn signal light bulb from the rear turn signal light socket.


4. REMOVE TAIL AND STOP LIGHT BULB

  1. E150059
    Turn the tail and stop light bulb and the tail and stop light socket in the direction indicated by the arrow and remove them as a unit.

  1. Remove the tail and stop light bulb from the tail and stop light socket.


5. REMOVE REAR BUMPER SIDE SUPPORT

  1. E150061
    Disengage the 2 claws and remove the rear bumper side support.

← REMOVAL (from Jul 2010)DISASSEMBLY (from Jul 2010) →