2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

DISASSEMBLY

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. REMOVE REAR BUMPER SIDE SUPPORT

  1. E212227
    Disengage the claw and remove the rear bumper side support.


2. REMOVE REAR COMBINATION LIGHT BODY GASKET

  1. E212228
    Remove the rear combination light body gasket.

    NOTICE:
    1. Be sure to remove all traces of the old gasket from the body.
    2. Do not reuse the removed gasket. Be sure to install a new rear combination light body gasket to prevent water ingress.


3. REMOVE REAR TURN SIGNAL LIGHT BULB

  1. E212229
    Turn the rear turn signal light bulb and the rear turn signal light socket in the direction indicated by the arrow and remove them as a unit.

  1. Remove the rear turn signal light bulb from the rear turn signal light socket.


4. REMOVE TAIL AND STOP LIGHT BULB

  1. E212231
    Turn the tail and stop light bulb and the tail and stop light socket in the direction indicated by the arrow and remove them as a unit.

  1. Remove the tail and stop light bulb from the tail and stop light socket.


5. REMOVE BACK UP LIGHT BULB

  1. E212233
    Turn the back up light bulb and the back up light socket in the direction indicated by the arrow and remove them as a unit.

  1. Remove the back up light bulb from the back up light socket.

← DISASSEMBLY (May 2007 – Jun 2010)REASSEMBLY (May 2007 – Jun 2010) →