2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Jul 2010


1. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY

HINT:
The double-sided tape and tape are not available as supply parts. If these tapes still have enough adhesion to secure the roof headlining and antenna cord, reuse the tapes. If the roof headlining has been replaced with a new one, or if the tape and/or the double-sided tape is no longer sticky, apply new tape following the procedures below.

  1. Apply new double-sided tape.

    E150570E01

    1. Remove the double-sided tape from the roof headlining assembly.

    2. Peel off the appropriate amount of new double-sided tape. Be careful not to touch the adhesive surface.

    3. Apply the double-sided tape to the roof headlining while aligning the tape with the markings on the roof headlining assembly.

    4. Peel off the backing sheet from the double-sided tape.

  1. Install the antenna cord to the roof headlining assembly from the front of the vehicle.

    E150569E01

  1. Put the strips of the tape back to the positions shown in the illustration in order to secure the antenna cord to the roof headlining assembly.

    HINT:
    For the right front corner of the roof headlining assembly, align the marking tape on the antenna cord with the protrusion of the roof headlining, and wrap tape around the antenna cord and roof headlining assembly once or twice to securely hold them.


2. INSTALL ROOF HEADLINING ASSEMBLY
(Click here)

3. INSTALL ANTENNA CORD SUB-ASSEMBLY

  1. Engage the 9 clamps and install the antenna cord sub-assembly.

    E151137E01


4. INSTALL NAVIGATION ANTENNA ASSEMBLY (w/ Navigation System)

  1. E150590
    Install the navigation antenna with the 2 screws.

  1. E150591
    Engage the 3 clamps and install the navigation antenna assembly.


5. INSTALL CENTER HEATER TO REGISTER SUB DUCT

  1. B168382
    Install the center heater to register sub duct with the 2 screws <E>.


6. INSTALL DEFROSTER NOZZLE ASSEMBLY

  1. B173016
    Install the defroster nozzle assembly with the 3 screws <E> and clip.


7. INSTALL SIDE NO. 2 DEFROSTER NOZZLE DUCT

  1. B168381
    Install the side No. 2 defroster nozzle duct with the screw <E>.


8. INSTALL SIDE NO. 1 DEFROSTER NOZZLE DUCT

  1. B168380
    Install the side No. 1 defroster nozzle duct with the screw <E>.


9. INSTALL NO. 4 HEATER TO REGISTER DUCT

  1. B168379
    Install the No. 4 heater to register duct with the 3 screws <E>.


10. INSTALL NO. 1 HEATER TO REGISTER DUCT

  1. B168378
    Install the No. 1 heater to register duct with the 3 screws <E>.


11. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY
(Click here)
← REMOVAL (from Jul 2010)COMPONENTS (May 2007 – Jun 2010) →