2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jul 2010


1. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY
(Click here)

2. REMOVE NO. 1 HEATER TO REGISTER DUCT

  1. B168378
    Remove the 3 screws <E> and the No. 1 heater to register duct.


3. REMOVE NO. 4 HEATER TO REGISTER DUCT

  1. B168379
    Remove the 3 screws <E> and the No. 4 heater to register duct.


4. REMOVE SIDE NO. 1 DEFROSTER NOZZLE DUCT

  1. B168380
    Remove the screw <E> and the side No. 1 defroster nozzle duct.


5. REMOVE SIDE NO. 2 DEFROSTER NOZZLE DUCT

  1. B168381
    Remove the screw <E> and the side No. 2 defroster nozzle duct.


6. REMOVE DEFROSTER NOZZLE ASSEMBLY

  1. B173016
    Remove the clip.

  1. Remove the 3 screws <E> and the defroster nozzle assembly.


7. REMOVE CENTER HEATER TO REGISTER SUB DUCT

  1. B168382
    Remove the 2 screws <E> and the center heater to register sub duct.


8. REMOVE NAVIGATION ANTENNA ASSEMBLY (w/ Navigation System)

  1. E150590
    Remove the 2 screws and separate the navigation antenna assembly.

  1. E150591
    Disengage the 3 clamps and remove the navigation antenna assembly.


9. REMOVE ANTENNA CORD SUB-ASSEMBLY

  1. Disengage the 9 clamps and remove the antenna cord sub-assembly.

    E151137E01


10. REMOVE ROOF HEADLINING ASSEMBLY
(Click here)

11. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY

  1. Peel the strips of the tape used to secure the antenna cord only to the extent that allows removal of the antenna cord.

    E150569E01

    HINT:
    Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining so that the tape can be reused.

  1. Remove the No. 2 antenna cord sub-assembly from the roof headlining.

← COMPONENTS (from Jul 2010)INSTALLATION (from Jul 2010) →