Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the cruise control system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.PROBLEM SYMPTOM CONFIRMATION

      NEXT


      3.CHECK CAN COMMUNICATION SYSTEM*
        Refer to PRECAUTION (Click here).
      1. Check for output DTCs.

        Result:
        Result
        Proceed to
        CAN DTC is not output
        A
        CAN DTC is output
        B

        HINT:
        The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.



      B.
      PROCEED TO "CAN COMMUNICATION SYSTEM"
      A


      4.DTC CHECK AND CLEAR*
        Refer to DTC CHECK / CLEAR (Click here).

      NEXT


      5.DTC CHECK (OTHER THAN CAN SYSTEM DTC)*

        Result:
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B



      A.
      GO TO STEP 7
      B


      6.DTC CHART
        Refer to DIAGNOSTIC TROUBLE CODE CHART (Click here).

      NEXT

      GO TO STEP 10


      7.PROBLEM SYMPTOM CONFIRMATION

        Result:
        Result
        Proceed to
        Symptom occurs
        A
        Symptom does not occur
        B



      A.
      GO TO STEP 9
      B


      8.SYMPTOM SIMULATION
        Refer to ELECTRONIC CIRCUIT INSPECTION PROCEDURE (Click here).

      NEXT

      GO TO STEP 7


      9.PROBLEM SYMPTOMS TABLE
        Refer to PROBLEM SYMPTOMS TABLE (Click here).

      NEXT


      10.CIRCUIT INSPECTION

        NEXT


        11.TERMINALS OF ECM
          Refer to TERMINALS OF ECM (Click here).

        NEXT


        12.IDENTIFICATION OF PROBLEM

          NEXT


          13.REPAIR OR REPLACE

            NEXT


            14.CONFIRMATION TEST

              NEXT

              END