Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Tachometer Malfunction

for Preparation Click here


DESCRIPTION

In this circuit, the meter CPU receives engine revolution signals from the ECM using the CAN communication lines (CAN No. 1 Bus). The meter CPU displays engine revolution data that is calculated based on the data received from the ECM.

WIRING DIAGRAM


E143765E06


INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if CAN communication DTC is output (Click here).

    Result:

    Result
    Proceed to
    CAN communication DTC is not output.
    A
    CAN communication DTC is output.
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Connect Techstream to the DLC3.

  1. Ignition switch on (IG).

  1. Turn the tester on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. Check the operation by referring to the values in the table below.

    Combination Meter: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Tacho Meter Operation
    Tachometer
    0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 (rpm)
    -

    OK:
    Needle indication is normal.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


3.READ VALUE USING TECHSTREAM (ENGINE SPEED SIGNAL)
  1. Connect Techstream to the DLC3.

  1. Start the engine.

  1. Turn the tester on.

  1. Enter the following menus: Body Electrical / Combination Meter / Data List.

  1. Check the values by referring to the values in the table below.

    Combination Meter: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Engine Rpm
    Engine speed/Min.: 0 rpm, Max.: 12750 rpm
    Almost same as actual engine speed (When engine is running)
    If data received from the ECM exceeds the range that can be displayed on the meter, the meter continues to display the maximum value of the range.

    OK:
    Engine speed displayed on the tester is almost the same as the actual engine speed.



NG
Go to step 4
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)  

4.READ VALUE USING TECHSTREAM (ENGINE SPEED SIGNAL)
  1. Connect Techstream to the DLC3.

  1. Ignition switch on (IG).

  1. Turn the tester ON.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List.

  1. Check the values by referring to the table below.

    Engine and ECT: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Engine Speed
    Engine speed/Min.: 0 rpm, Max.: 16383.75 rpm
    Almost same as actual engine speed (When engine is running)
    -

    OK:
    Engine speed displayed on the tester is almost the same as the actual engine speed.



NG
GO TO SFI SYSTEM (for 2GR-FE) (Click here)
OK


5.REPLACE ECM (for 2GR-FE)
  1. Replace the ECM with a new or a normal one
    OK

    END