VEHICLE STABILITY CONTROL SYSTEM > TS and CG Terminal Circuit |

| 1.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - TS of DLC3) |
![]() |
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A24-33 (TS) - D47-12 (TS) | Always | Below 1 Ω |
| A24-33 (TS) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D47-4 (CG) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||