Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the tire pressure warning system.
  2. *: Use Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer to confirm the trouble.

      HINT:
      It is important to collect as much specific information as possible from the customer to allow for a quick repair.


    NEXT


    3.ADJUST TIRE PRESSURE
    1. Turn the ignition switch off.

    2. Connect Techstream to the DLC3.

    3. Turn the ignition switch on (IG) and turn the tester on.

    4. Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

    5. Read the "ID Tire Inflation Pressure" values.

    6. Adjust all tire pressures to the standard values (Click here).

    7. Check the DATA LIST (Click here).

      HINT:
      1. It takes about 2 or 3 minutes to display the updated tire pressure data.
      2. If the problem is that the tire pressure decreases, wait until all of the tire pressure data is received by the ECU. If the data is received, the tire pressure warning light will turn off.

        Result:
        Condition
        Proceed to
        Tire pressure warning light remains on
        A
        Tire pressure warning light goes off
        B



    B.
    GO TO STEP 9
    A


    4.CHECK FOR DTC*
    1. Check for DTCs (Click here).

      Result:
      Result
      Proceed to
      DTC is output
      A
      DTC is not output
      B



    B.
    GO TO STEP 6
    A


    5.DTC CHART
    1. Refer to DIAGNOSTIC TROUBLE CODE CHART (Click here).


    NEXT

    GO TO STEP 8


    6.PROBLEM SYMPTOMS TABLE
    1. Refer to PROBLEM SYMPTOMS TABLE (Click here).


    NEXT


    7.CIRCUIT INSPECTION*
    1. Refer to ELECTRONIC CIRCUIT INSPECTION PROCEDURE (Click here).


    NEXT


    8.REPAIR OR REPLACE
    1. Repair or replace parts based on the diagnosis result.


    NEXT


    9.CONFIRMATION TEST
    1. Check the DATA LIST to confirm that the tire inflation pressure has been received (Click here).

    2. Perform initialization (Click here).

    3. Confirm that the initialization has been completed.


    NEXT

    END