Home › ENGINE › 2GR-FE STARTING › SMART KEY SYSTEM

DTC    B2286    Runnable Signal Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when serial communication signals and CAN communication signals in the circuit between the main body ECU (instrument panel junction block) and ECM are inconsistent.

HINT:
When the main body ECU (instrument panel junction block) is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU (instrument panel junction block) is replaced, perform the registration procedures for the engine immobiliser system (Click here).


DTC No.
DTC Detection Condition
Trouble Area
B2286
Serial communication signals and CAN communication signals in the circuit between the main body ECU (instrument panel junction block) and ECM are inconsistent.
  1. CAN communication system
  2. ECM
  3. Main body ECU (instrument panel junction block)
  4. Wire harness or connector

WIRING DIAGRAM


B177531E01


INSPECTION PROCEDURE

1.CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM)
  1. Delete the DTCs (Click here).

  1. Check for CAN communication system (Click here).

    HINT:
    If the DTCs for the CAN communication system malfunction are output, inspect those DTCs first (Click here).

    OK:
    No DTC is output.



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK


2.READ VALUE USING TECHSTREAM
  1. Connect Techstream to the DLC3.

  1. Check the DATA LIST for proper functioning of the engine.

    HINT:
    When using Techstream with the engine switch off, turn on and off any of the door courtesy light switches repeatedly at 1.5 second intervals or less until communication between the tester and vehicle starts.


    Main Body: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    E/G Cond
    Engine condition/STOP or RUN
    STOP: Engine is stopped
    RUN: Engine is running
    -

    OK:
    STOP (engine is stopped) and RUN (engine is running) appear on the screen.



NG
Go to step 3
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) 

3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM)


  1. Disconnect the D36 ECM connector.


    B176968E01

  1. Disconnect the D9 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D9-8 (TACH) - D36-1 (TACH)
    Always
    Below 1 Ω
    D9-8 (TACH) or D36-1 (TACH) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)