Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Stereo Component Amplifier Communication Error

for Preparation Click here


INSPECTION PROCEDURE

1.IDENTIFY THE COMPONENT SHOWN BY SUB-CODE


    E136189E20
  1. Enter the diagnostic mode.

  1. Press the "LAN Mon" switch to change the mode to "LAN Monitor" mode.

  1. Identify the component shown by the sub-code.

    HINT:
    1. "110 (multi-display)" is the component shown by the sub-code in the example shown in the illustration.
    2. The sub-code will be indicated by its physical address.
    3. For the component list, refer to "DIAGNOSIS DISPLAY DETAILED DESCRIPTION" (Click here).


NEXT


2.CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
  1. Inspect the power source circuit of the component shown by the sub-code.
    If the power source circuit is operating normally, proceed to the next step.

    Component Table: 
    Component
    Proceed to
    140 (Navigation receiver assembly)
    Navigation receiver assembly power source circuit (Click here)
    1B0 (Television display assembly)
    Television display assembly power source circuit (Click here)


NEXT


3.INSPECT NAVIGATION RECEIVER ASSEMBLY
  1. Disconnect the navigation receiver assembly connectors.


E153725E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E15-9 (TXM+) - E15-10 (TXM-)
    Always
    60 to 80 Ω
    E2-5 (ATX+) - E2-15 (ATX-)
    Always
    60 to 80 Ω



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER - COMPONENT SHOWN BY SUB-CODE)

HINT:
  1. Start the check from the circuit that is near the component shown by the sub-code first.
  2. For details of the connectors, refer to "TERMINALS OF ECU" (Click here).



  1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the stereo component amplifier and the component shown by the sub-code.

    1. Disconnect all connectors between the stereo component amplifier and the component shown by the sub-code.



    2. Check for an open or short in the AVC-LAN circuit between the stereo component amplifier and the component shown by the sub-code.


      E152952E01

      OK:
      There are no open or short circuits.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE COMPONENT SHOWN BY SUB-CODE
  1. Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.

    OK:
    Same problem does not occur.



NG
REPLACE STEREO COMPONENT AMPLIFIER (Click here)
OK

END