AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK |
| |||||
| 3.INSPECT BATTERY VOLTAGE |
| |||||
| 4.CHECK CAN COMMUNICATION SYSTEM* |
Use Techstream to check if the CAN communication system is functioning.
| Result | Proceed to |
| CAN DTC is not output | A |
| CAN DTC is output | B (Click here) |
|
| ||||
| |||||
| 5.CHECK FOR DTC |
Check for DTCs.
Write down the DTCs.
Clear the DTCs.
Check whether the DTCs recur.
Reproduce the problem symptoms in accordance with the DTCs that were written down, and check whether the DTCs recur.
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| |||||
| 6.REFER TO PROBLEM SYMPTOMS TABLE |
| Result | Proceed to |
| Fault not listed in problem symptoms table | A |
| Fault listed in problem symptoms table | B |
|
| ||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING* |
DATA LIST / ACTIVE TEST (Click here)
Panel diagnosis (indicator check) (Click here)
Panel diagnosis (sensor check) (Click here)
Panel diagnosis (actuator check) (Click here)
Terminals of ECU (Click here)
| |||||
| 8.ADJUST, REPAIR OR REPLACE |
| |||||
| 9.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|