Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

ENGINE IMMOBILISER SYSTEM (w/o Smart Key System) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure to troubleshoot the engine immobiliser system.
  2. Techstream should be used in steps 5, 6, and 8.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS CHECK

      HINT:
      1. In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
      3. The following 5 items are important points in the problem analysis:


      What
      Vehicle model, system name
      When
      Date, time, occurrence frequency
      Where
      Road conditions
      Under what conditions?
      Driving conditions, weather conditions
      How did it happen?
      Problem symptoms

    NEXT


    3.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage.

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


    NEXT


    4.CRANK ENGINE FOR MORE THAN 10 SECONDS

      NEXT


      5.CHECK FOR DTCS
      1. Check for DTCs and note any codes that are output (Click here).

      2. Delete the DTCs.

      3. Recheck for DTCs. Try to duplicate the DTCs (SFI system and engine immobiliser system) by simulating the symptoms indicated by the DTCs.

        Result:

        Result
        Proceed to
        DTC (SFI system) recurs
        A
        (Click here)
        DTC (engine immobiliser system) recurs
        B
        (Click here)
        DTC does not recur
        C



      A.
      GO TO SFI SYSTEM (DTC CHART)

      B.
      GO TO ENGINE IMMOBILISER SYSTEM (DTC CHART)
      C


      6.READ VALUE ON TECHSTREAM
      1. Connect Techstream to the DLC3.

      2. Turn the ignition switch to the ON position.

      3. Turn the tester on.

      4. Select the following menu items: Body Electrical / Immobiliser / Data List.

      5. Select Key SW in the Data List and read the tester display.

        Immobiliser (Transponder Key ECU): 
        Tester Display
        Measurement Item/Range
        Normal Condition
        Diagnostic Note
        Key SW
        Unlock warning switch signal/ON or OFF
        ON: Key is in ignition key cylinder
        OFF: No key is in ignition key cylinder
        -

        OK:
        ON (Key is in ignition key cylinder) appears on the screen.



      NG.
      GO TO DTC B2780
      OK


      7.PROBLEM SYMPTOMS TABLE

        Result:

        Result
        Proceed to
        Fault is listed in problem symptoms table
        A
        Fault is not listed in problem symptoms table
        B



      A.
      GO TO STEP 9
      B


      8.OVERALL ANALYSIS AND TROUBLESHOOTING
      1. DATA LIST / ACTIVE TEST (Click here)

      2. TERMINALS OF ECU (Click here)


      NEXT


      9.ADJUST, REPAIR OR REPLACE

        NEXT


        10.CONFIRMATION TEST

          NEXT

          END