Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

DTC    B2796    No Communication in Immobiliser System

DTC    B2798    Communication Malfunction No. 2

for Preparation Click here


DESCRIPTION

These DTCs are output if a key that does not have a transponder chip is inserted into the ignition key cylinder or if communication between the key and transponder key ECU assembly is impossible.

DTC No.
DTC Detection Condition
Trouble Area
B2796
The key code cannot be transmitted
  1. Key
  2. Transponder key amplifier
  3. Transponder key ECU assembly
B2798
Key code identification cannot be completed within the specified time (0.15 to 0.5 sec.)
  1. Key
  2. Transponder key amplifier
  3. Transponder key ECU assembly

WIRING DIAGRAM


B164252E04


INSPECTION PROCEDURE

NOTICE:
  1. If the transponder key ECU is replaced, register the key and ECU communication ID (Click here).
  2. If the key is replaced, register the key (Click here).

1.READ VALUE ON TECHSTREAM (IMMOBILISER SYSTEM STATUS)
  1. Connect Techstream to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Turn the tester on.

  1. Select the following menu items: Body Electrical / Immobiliser / Data List.

  1. Select Immobiliser in the Data List and read the tester display.

    Immobiliser (Transponder Key ECU): 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Immobiliser
    Immobiliser system status/SET or UNSET
    UNSET: Ignition switch ON
    SET: Without key
    -

    OK:
    UNSET (Ignition switch ON) appears on the screen.



NG
Go to step 2
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY (Click here)  

2.CHECK KEYS
  1. Insert the vehicle's other key into the ignition key cylinder.

  1. Check that the engine starts with this key.

    OK:
    The engine starts.



NG
Go to step 5
OK


3.RE-REGISTER KEY
  1. Re-register the key (Click here).


NEXT


4.CHECK ENGINE START
  1. Check that the engine starts.

    OK:
    The engine starts.



NG
REPLACE KEY
OK

END (PROBLEM WITH KEY REGISTRATION IS DEFECTIVE) 

5.REPLACE TRANSPONDER KEY AMPLIFIER
  1. Replace the transponder key amplifier (Click here).


NEXT


6.CHECK ENGINE START
  1. Check that the engine starts.

    OK:
    The engine starts.



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY (Click here)
OK

END (TRANSPONDER KEY AMPLIFIER IS DEFECTIVE)