ENGINE IMMOBILISER SYSTEM (w/ Smart Key System) > Certification ECU Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BATTERY) |
![]() |
Disconnect the certification ECU (smart key ECU assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D40-1 (+B) - Body ground | Always | 11 to 14 V |
| D40-18 (IG) - Body ground | Engine switch off | Below 1 V |
| D40-18 (IG) - Body ground | Engine switch on (IG) | 11 to 14 V |
| D40-19 (ACC) - Body ground | Engine switch off | Below 1 V |
| D40-19 (ACC) - Body ground | Engine switch on (ACC) | 11 to 14 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D40-17 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||