Home › STEERING › POWER STEERING › POWER STEERING SYSTEM

POWER STEERING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Perform troubleshooting in accordance with the following flowchart.
*: Use Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK DTC AND FREEZE FRAME DATA*

      NEXT


      4.PROBLEM SYMPTOM CONFIRMATION

        NEXT


        5.CHECK CAN COMMUNICATION SYSTEM*
        1. Check for DTCs (Click here).

          Result:
          Result
          Proceed to
          CAN system DTC is not output
          A
          CAN system DTC is output
          B

          HINT:
          1. When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.
          2. When communication to the power steering ECU is not established through Techstream, inspect terminals SIL of the DLC3 and the power steering ECU, and the IG circuit of the power steering ECU.



        B.
        GO TO CAN COMMUNICATION SYSTEM (Click here).
        A


        6.CHECK DTC*
        1. Check for DTCs (Click here).

          Result:
          Result
          Proceed to
          DTC is not output
          A
          DTC is output
          B



        B.
        Go to step 9
        A


        7.PROBLEM SYMPTOMS TABLE
        1. PROBLEM SYMPTOMS TABLE (Click here).

          Result:
          Result
          Proceed to
          Fault is not listed in problem symptoms table
          A
          Fault is listed in problem symptoms table
          B



        B.
        Go to step 9
        A


        8.OVERALL ANALYSIS AND TROUBLESHOOTING*
        1. TERMINALS OF ECU (Click here).

        2. DATA LIST / ACTIVE TEST (Click here).


        NEXT


        9.REPAIR OR REPLACE

          NEXT


          10.CONFIRMATION TEST

            NEXT

            END