POWER STEERING SYSTEM > EPS Warning Light Circuit |


| 1.CHECK FOR DTC (CAN COMMUNICATION SYSTEM) |
Turn the ignition switch off.
Connect Techstream to the DLC3.
Turn the ignition switch on (IG).
Turn Techstream on.
Using Techstream, check for DTCs and confirm that there are no problems in the CAN communication system.
|
| ||||
| OK | |
| 2.READ VALUE USING TECHSTREAM (IG POWER SUPPLY) |
Enter the following menus: Chassis / EMPS / Data List.
Select the item "IG Power Supply" in the Data List and read the value displayed on Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| IG Power Supply | ECU power source voltage: Min.: 0 V Max.: 20.1531 V | 11 to 14 V | Ignition switch on (IG) |
|
| ||||
| OK | |
| 3.PERFORM ACTIVE TEST BY TECHSTREAM |
Enter the following menus: Body / Combination meter / Active Test.
According to the display on tester, perform the "Active Test".
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. EPS (*1) | P/S Warning Light | ON or OFF | Confirm that the vehicle is stopped, engine idling |
| Master Warning (*2) | Master Warning Light | ON or OFF | Confirm that the vehicle is stopped, engine idling |
|
| ||||
| OK | ||
| ||
| 4.INSPECT FUSE (ECU IG1) |
Remove the ECU IG1 fuse from the instrument panel junction block.
Measure the resistance of the fuse.
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the connectors from the power steering ECU.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D6-5 (IG) - Body ground | Ignition switch on (IG) | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D5-2 (PGND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 6.PERFORM ACTIVE TEST USING TECHSTREAM |
Enter the following menus: Body / Combination meter / Active Test.
According to the display on tester, perform the "Active Test".
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. EPS (*1) | P/S Warning Light | ON or OFF | Confirm that the vehicle is stopped, engine idling |
| Master Warning (*2) | Master Warning Light | ON or OFF | Confirm that the vehicle is stopped, engine idling |
|
| ||||
| OK | ||
| ||