DTC B2288 Steering Lock Signal Circuit Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2288 | After turning engine switch from off to on (IG), the steering wheel does not unlock for a certain period of time (ECU unlocks steering wheel only when it receives an unlock signal from LIN communication and cable) |
|

| 1.CHECK FOR DTCS |
Delete the DTCs (Click here).
After all DTCs are cleared, check if the trouble occurs again 18 to 22 seconds after the engine switch is turned on (IG).
Check for DTCs again.
| Result | Proceed to |
| DTC B2285 (Steering lock Position Signal Circuit Malfunction) is output | A |
| Steering lock DTCs B2781, B2782 and / or B2788 are output | B |
| DTC is not output | C |
|
| ||||
|
| ||||
| C | |
| 2.CHECK STEERING LOCK |
Check if the steering lock is released when turning the engine switch on (ACC).
|
| ||||
| OK | |
| 3.READ VALUE USING TECHSTREAM |
Connect Techstream to the DLC3.
Check the DATA LIST for proper functioning of the steering lock function.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Str Unlock SW | Steering lock condition / ON or OFF | ON: Steering is unlocked (Engine switch on (ACC)) OFF: Steering is locked (Engine switch off) | - |
|
| ||||
| OK | ||
| ||