SMART KEY SYSTEM > Front Passenger Side Door Entry Unlock Function does not Operate |

| 1.CHECK POWER DOOR LOCK OPERATION |
When the door control switch on the master switch assembly is operated, check that the locked doors unlock (Click here).
|
| ||||
| OK | |
| 2.READ VALUE ON TECHSTREAM (DOOR OUTSIDE HANDLE) |
Connect Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the tester on.
Enter the following menus:
Body Electrical / Smart Key / Data List.
Select P Touch Sensor in the Data List and read the tester display.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| P Touch Sensor | Status of touch sensor front LH / ON or OFF | ON: Touch sensor is touched OFF: Touch sensor is not touched | - |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - DOOR ELECTRICAL KEY OSCILLATOR) |
![]() |
Disconnect the certification ECU (smart key ECU assembly) and door electrical key oscillator connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D40-6 (SEL2) - z16-4 (SEL) | Always | Below 1 Ω |
| D40-23 (SEN2) - z16-6 (SENS) | Always | Below 1 Ω |
| D40-6 (SEL2) - Body ground | Always | 10 kΩ or higher |
| D40-23 (SEN2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (DOOR ELECTRICAL KEY OSCILLATOR - FRONT DOOR OUTSIDE HANDLE) |
![]() |
Remove the front door outside handle (Click here).
Disconnect the touch sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| z15-6 (SGT) - z16-2 (SGT) | Always | Below 1 Ω |
| z15-6 (SGT) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.REPLACE DOOR ELECTRICAL KEY OSCILLATOR |
Replace the door electrical key oscillator (Click here).
| NEXT | |
| 6.CHECK DOOR ELECTRICAL KEY OSCILLATOR (OPERATION) |
Check that the entry functions operate normally.
|
| ||||
| OK | ||
| ||
| 7.REPLACE FRONT DOOR OUTSIDE HANDLE |
Replace the front door outside handle LH (Click here).
| NEXT | |
| 8.CHECK FRONT DOOR OUTSIDE HANDLE (OPERATION) |
Check that the entry functions operate normally.
|
| ||||
| OK | ||
| ||