Home › BODY ELECTRICAL › DOOR LOCK › KEY REMINDER WARNING SYSTEM

KEY REMINDER WARNING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the key reminder warning system.
  2. Techstream should be used in steps 4 and 6.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS CHECK

      HINT:
      1. In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

      1. The following 5 items are important points in the problem analysis:

        What
        Vehicle model, system name
        When
        Date, time, occurrence frequency
        Where
        Road conditions
        Under what conditions?
        Driving conditions, weather conditions
        How did it happen?
        Problem symptoms

    NEXT


    3.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage.

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


    NEXT


    4.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM
    1. Use Techstream to check if the CAN communication system is functioning normally.

      Result:

      Result
      Proceed to
      (ECU connected, communication line malfunctioning) DTC is not output.
      A
      (ECU connected, communication line malfunctioning) DTC is output.
      B
      (Click here)



    B.
    GO TO CAN COMMUNICATION SYSTEM
    A


    5.PROBLEM SYMPTOMS TABLE

      Result:

      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B



    B.
    GO TO STEP 7
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. DATA LIST / ACTIVE TEST (Click here)

    2. TERMINALS OF ECU (Click here)


    NEXT


    7.REPAIR OR REPLACE

      NEXT


      8.CONFIRMATION TEST

        NEXT

        END